Anilam 1400m

[quadbob]

I did the internal self diagnostics that Anilam 1400m uses. I got an error code"FFFF" in the hard disk surface test. Does anyone know what it means. I would gues it means there is a bad sector on disk, but what does one do about it. There is nowhere in the manual that explains any of the diagnostic tools available. Thanks.

[bdambacher@dsl.]

If the control works i would not worry about it. I think the product was not quite "finished" so i would not trust the diagnostics too much.. it is obsolete now

[Saddletramp1200]

Hi, I need the software for a TW 105 RH mill. The table will not home X axis. Is there a diagnostic built into the program? The table goes the wrong way when homing and shuts the servo off. Please help!

[elkflugan]

I am trying to understand Anilam 1400M, which I have on my bed mill. This is my first CNC machine and I need a starting point so I can get going and make some parts. Can someone give me a hand?
9516521148

[bertcnc]

Are you having difficulty operating the machine or programing it? Have you got a tool changer?

[bertcnc]

Hi, I need the software for a TW 105 RH mill. The table will not home X axis. Is there a diagnostic built into the program? The table goes the wrong way when homing and shuts the servo off. Please help!

What version of software do you have? It is shown on the screen at power up. Does the Z home OK?