XyDrive XD3 problems

[neric]

XyDrive XD3
I have just purchase one of these and I am wondering if it is design to work with Mach3 or any other software I am hooking it up to RMS technologies R701 but for no success the third day in a raw now I was wondering what is it mean to try to change the signal to TTL and how would I check that it is on and how would I change it if it is not

[crazyjoe86]

Did you ever find out what the yellow dots (enable's) hooked up to...I'm also interested in this board

[neric]

well, no need to figure out...I end up getting the this board the xy drive didnt work in any configuration a waste of money and time.