Newbie Controller and servo. - CNCzone.com-The Largest Machinist Community on the net!

06-18-2009, 01:18 PM

Join Date: Apr 2005

Location: Denmark

Age: 49

Posts: 1

Controller and servo.

permalink

Are these a reasonable starting point to make a controller and driver setup for a CNC router:

Controller:
Servo-300 from ICP-DAS
http://www.icpdas.com.tw/products///.../servo_300.htm

Servo driver:
3 of: MiniAx 60x10/20
http://www.controltechniques.com/pro....asp&mainFrame

The point is that I have these components.
Should I stick with them or start somewhere else?
Any comment is welcome :-)

rgds
Uffe

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Elm Dc Servo Controller???	smartgsm	Open Source Controller Boards	433	05-12-2012 09:49 AM
ADE-SMC DIY Servo controller	ade_cnc	Open Source Controller Boards	19	06-13-2009 02:09 PM
Galil Motion Controller, with NEMA 23 Servo Motors, Servo Drive, Encoders, Etc.	qualitymachine	EBAY ADS	0	06-01-2009 02:26 PM
Just IN- servo controller	Rony.sn	Product Announcements & Manufacturer News	0	03-23-2008 12:32 PM
Need help for servo controller box	osdhillon	General Electronics Discussion	2	02-07-2005 02:23 PM

All times are GMT -5. The time now is 10:12 AM.