| |
|
#1
 
06-04-2009, 12:43 PM
| |||
| |||
I have a centroid encoder and driver boards from an old cnc router and I am curios if i might be able to use the driver boards some how with a breakout board. Do these boards use step and dir signals from the encoder? If they do how would I figure out what pins are what? Here is a link to one of the driver boards... http://www.flickr.com/photos/3807474...7619243987528/ If not is this stuff worth anything? Should I just toss it? Thanks, Joe  |
 |
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Help!- Nema 34 driver boards | Tony611 | General Electronics Discussion | 1 | 12-08-2008 06:28 AM |
| Need Help!- Optocoupled driver boards | alphamail | General Electronics Discussion | 9 | 09-29-2008 03:18 AM |
| Need Help!- Looking for new Driver Boards: Please Help | SpeedsCustom | Benchtop Machines | 19 | 06-13-2008 07:54 AM |
| cheapest driver boards - nearly there. | droddis | DIY-CNC Router Table Machines | 8 | 12-14-2007 08:18 AM |
| Driver Boards?? | mocnc | DIY-CNC Router Table Machines | 9 | 12-13-2005 09:04 AM |
| | |
Linear Mode
