| |
|
#1
 
03-15-2009, 03:39 PM
| |||
| |||
hi all i'm so proud of this site and all its' members and the cooperation done here i'll go straight to the point , i'm asking about the driver board of stepper motors , does it differ from stepper motor to another or i can make a universal drive board for all stepper motors? and what's the sequence i have to go on? (driver and stepper) thanks for ur replies   |
 |
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Newbie- Best MOSFET Driver and MOSFET choice for an H-Bridge Stepper Driver? | joprinz | General Electronics Discussion | 4 | 04-28-2011 03:57 AM |
| Newbie- Can I use this Driver with a stepper? | blue_steel | Stepper Motors and Drives | 2 | 09-18-2008 11:53 PM |
| Wanted DIY stepper driver circuit for 6 wire stepper motors | Colin300 | Australia, New Zealand Club house | 5 | 09-20-2007 09:20 PM |
| STEPPER DRIVER FAQ {Stepper/driver amp per phase match. | huios | Stepper Motors and Drives | 0 | 08-27-2006 08:43 AM |
| New Stepper Driver?? | ViperTX | Stepper Motors and Drives | 3 | 08-04-2005 06:46 PM |
| | |
Linear Mode
