| |
|
#1
 
09-19-2008, 04:33 AM
| |||
| |||
hi there people just wondering (as i'm new to this cnc stuff) where i could get plans for a controller borad that i can build myself that will run this type of motor the reason i am looking to build myself is because i have limited funds and cannot afford the pre built ones i.e. Gecko the stepper has the following specs: Rated Current(A) 4.2 Phase Resistance(ohm) 0.9 Phase Inductance(mH) 3.8 Biploar Mode Only so wondering if anyone out there knows of i board i could home build to run this motor Cheers    |
 |
| Tags |
| controller, driver, motor controller, motor help |
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| plans for joystick controller | erkiwi | DeskCNC Controller Board | 6 | 11-14-2008 11:07 AM |
| Plans? | cnc-newb | Vertical Mill, Lathe Project Log | 1 | 12-10-2007 08:02 AM |
| Plans | nev25 | JGRO Router Table Design | 1 | 06-08-2007 01:08 PM |
| DeskCNC 2nd. gen controller AND HobbyCNC Pro Controller | maycom | DeskCNC Controller Board | 1 | 06-02-2007 02:33 PM |
| New EDM plans | ariel 1 | CNC Plasma and Waterjet Machines | 4 | 04-01-2007 06:27 PM |
| | |
Linear Mode
