| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| | |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#2
03-12-2008, 11:33 AM
| ||||
| ||||
| www.rogersmachine.net. Not true closed loop, but it will monitor potion and notify mach3 to stop if an error occurs. I don't know of any true closed loop DIY stepper systems.
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)    |
|
#3
03-12-2008, 11:47 AM
| |||
| |||
| Atleast one person has done it with emc2.. (using encoders to trip a following error realtime.) (I don't have a bob solution.. I think he hooked them directly into the printer port.) Some light reading... EMC2 + Steppers + Encoders = following error detection (so far) :) http://wiki.linuxcnc.org/cgi-bin/emc..._With_Encoders EMC+closed loop? and as always.. http://www.linuxcnc.org/ http://wiki.linuxcnc.org/cgi-bin/emc...cKnowledgeBase |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| what USB Breakout Board to by ?? | dbss | General Electronics Discussion | 5 | 01-19-2008 08:54 AM |
| Breakout board, Relays on board? | Cooper | Open Source Controller Boards | 11 | 06-09-2007 08:55 PM |
| Best breakout board? | nate | Xylotex | 1 | 01-03-2007 08:39 AM |
| how to hook breakout board to geckos? | Apples | Gecko Drives | 5 | 09-06-2005 08:05 AM |
| board hook-ups | landart | DIY-CNC Router Table Machines | 2 | 11-29-2003 10:49 AM |
| | |
breakout board with encoder hook ups 
Linear Mode
