Cheap stepper/servo controllers - CNCzone.com-The Largest Machinist Community on the net!

blackbeard52 · #1 01-24-2008, 07:14 AM

I found this site while browsing the REPRAP site blogs. I cant believe the prices of the controller kits. I am not sure if they are assembled but either way if they are sufficient for your needs!

P.S. it appears that they charge a $25 shipping fee for small orders so joinup with others and/or shop for the future also it appears that a large order is shipped free.

http://www.anykits.com/

tonykat · #2 02-23-2008, 05:36 PM

Hi, its a good find this site, the bipolar board is nearly the same as the ones I built from the book by Geoff Williams, and a lot cheaper than they cost me! If I need any more I'll use this site, thanks.
Tony

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need help finding servo controllers	CreativeOffroad	Controller Cards	7	01-16-2009 03:02 AM
Pic stepper motor controllers	roni21702	PicStep Controllers	1	04-07-2006 12:18 PM
Possible CHEAP drivers, stepper and/or servo	NeoMoses	General Electronics Discussion	5	03-23-2004 02:45 PM
Cheap DNC/ remote request for Heidenhain controllers	Mouldmaker	Mazak, Mitsubishi, Mazatrol	0	02-24-2004 02:20 AM
stepper controllers - - -help please	camfambmw5	DIY-CNC Router Table Machines	5	09-20-2003 01:59 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)