| |
|
#1
 
01-12-2008, 02:33 PM
| |||
| |||
Hi, I cannot acces to www.aliencnc.com Could some one post the datasheet of ths 4 axis 1/8 microstepping driver octostep ver 1.0 ? Thank you.    |
|
#2
01-14-2008, 03:59 PM
| |||
| |||
I have a 3-axis aliencnc driver board. Their website appears to be shut down. I found that Stepmaster has a similar data sheet and installation instructions to the aliencnc datasheet I printed out. Much of the text is identical. The Stepmaster board is adjustable for full, 1/2, 1/4 & 1/8 microstepping, while my octostep board is not. Try http://www.stepmasternc.com/stepmasternc_009.htm I read on another site that the aliencnc was made by stepmaster. Good luck! |
 |
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Datasheet KP56QM2 | HobbyGG | Stepper Motors and Drives | 2 | 02-16-2008 03:35 AM |
| Datasheet for STP-58d5008 | brotherjohn | Stepper Motors and Drives | 0 | 05-02-2007 03:15 PM |
| Need Datasheet NEC PS2510-4 Optocoupler | CJL5585 | General Electronics Discussion | 6 | 12-07-2006 06:55 PM |
| DataSheet Search Site. | datasheet | Stepper Motors and Drives | 0 | 07-29-2005 09:14 PM |
| DataSheet Search Site.... | datasheet | Fadal | 1 | 07-07-2005 01:01 AM |
| | |
Need datasheet 
Linear Mode
