| |
|
#1
 
11-24-2007, 12:06 AM
| |||
| |||
hi guys can pc electronics or even a printer controller be converted to a cnc controller? thanks    |
|
#2
11-24-2007, 11:27 AM
| ||||
| ||||
| Do you mean PC based CNC software control? If so search for Mach or Linux based. If you mean PC based, hardware CNC then Galil motion offer a PC based system, the PC is used for the HMI. Al.
__________________ “Logic will get you from A to B. Imagination will take you everywhere.” Albert E. (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
 |
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Open Source Boards Available, Stepper Drivers and Break Out Boards | pminmo | Open Source Controller Boards | 762 | 11-21-2011 11:51 PM |
| Memory boards!!! | mmachining | HURCO | 10 | 11-11-2007 01:07 AM |
| Breakout boards | DaPyro | General Electronics Discussion | 15 | 06-23-2006 02:22 PM |
| help with boards | mocnc | General Electronics Discussion | 15 | 02-17-2005 09:18 PM |
| | |
Linear Mode
