| |
|
#1
 
08-15-2007, 08:19 PM
| |||
| |||
| Ever used these Stepper cards? Well I ran across these control cards the other day I linked from cnczone there and I was wondering if anyone has ever used these cards and what do they think of them? They fit what I need but if there no good then I will just opt for some geckos but I would rather not as they are more expensive and I really dont need more than 3 amps and 50 volts (64 volts is 20 times rated voltage of my motors). Thanks for the input. http://www.circuitspecialists.com/prod.itml/icOid/8922    |
 |
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| So which I/O cards do you use with CamSoft | Metalmog | CamSoft Products | 3 | 12-11-2006 02:49 PM |
| VF3 Drive Cards | Burgs | Haas Mills | 0 | 08-27-2005 04:08 AM |
| Analogue output cards | mmjpotter | Computers and Networking | 5 | 11-05-2004 07:59 PM |
| Sources for I/O cards | HuFlungDung | General Electronics Discussion | 13 | 10-13-2003 10:20 PM |
| | |
Linear Mode
