| |
|
#1
 
06-16-2007, 10:03 AM
| |||
| |||
how can i tell if this for steppers or brush thank you    |
|
#2
06-16-2007, 10:27 AM
| ||||
| ||||
| Kevin, I have sent you a PM. Al.
__________________ “Logic will get you from A to B. Imagination will take you everywhere.” Albert E. (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
 |
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Acroloop 8000 | MrWild | General CNC (Mill and Lathe) Control Software (NC) | 3 | 06-16-2006 07:38 PM |
| Acroloop 8000 and Omron driver compatability | Aerobuilt | Servo Motors and Drives | 9 | 04-08-2006 11:28 PM |
| | |
How Do I Know ? Acr 8000 
Linear Mode
