| |
|
#1
04-25-2007, 08:59 AM
| ||||
| ||||
Can anyone tell me what is the skinny on this new board cnPod from artofcnc?
__________________ Thank You, Paul G Site Owner-Webmaster- Administrator www.rfqwork.com www.cnczone.com www.welderzone.com    |
|
#2
04-25-2007, 11:23 AM
| ||||
| ||||
| It's not from Artsoft. It's made by the DeskCNC developer. Art has written a plugin so that Mach3 supports it. It's still in beta, but the Mach3 plugin is mostly complete. I think there are some firmware changes still being done, and I've heard when the ncPod beta testing is complete, the hardware may change slightly, or more features may be added.
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
 |
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Time for ncPod forum yet? | Greolt | Suggestions for the CNCzone.com site. | 5 | 01-13-2007 03:43 AM |
| | |
Linear Mode
