| |
|
#1
 
06-16-2011, 12:12 AM
| |||
| |||
Hi, does anyone use the CPU V4 controller from USBCNC? I would like to have a go at making an MPG for it and was wondering if anyone had already done it and could help out?  |
|
#2
05-23-2012, 11:23 AM
| |||
| |||
| Here is a link that I had recommended to me directly from the makers of USBCNC which is Eding CNC Full Built: DamenCNC.com - MPG Handwheel and a kit from a diffdernt manufacturer, but also recommended: Sorotec - Handradbausatz I am just getting into this myself, but if these are the manufacturer recommendations, I'd like to feel that means something. Best of luck! |
 |
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| almotion usbcnc | the evil E | Haas Mills | 1 | 11-24-2010 04:40 PM |
| Vectric-PPs for USBCNC | elses | Post Processors | 1 | 11-04-2009 04:24 PM |
| postprocessor for USBCNC | Blerbaby | EdgeCam | 3 | 10-29-2009 06:25 AM |
| USBCNC now comes with hardware for a really low price!! | bert_eding | General CNC (Mill and Lathe) Control Software (NC) | 1 | 09-09-2009 11:16 AM |
| | |
Linear Mode
