| |
|
#1
 
11-06-2010, 02:36 PM
| |||
| |||
I am using a Univelop control board with a vexta stepper motor on my Z axis. When I drive the axis in the up direction or the down direction sometimes the motor will drive in the wrong direction. Sometimes it will only drive in one direction and tapping the up or down keyy several times it will drive up and down with the same key. What am I doing wrong and how do I correct this problem?  |
 |
| Tags |
| help! |
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| What stepper IC controller do you use? | DeekStarr | Polls | 12 | 09-25-2010 02:08 AM |
| $29.95 Stepper controller | widgitmaster | General Electronics Discussion | 8 | 10-31-2005 07:27 PM |
| Stepper Controller | Dre361224 | General Electronics Discussion | 1 | 06-09-2005 05:41 PM |
| stepper controller...need help | DragnsBane | General Electronics Discussion | 2 | 09-10-2004 09:49 PM |
| USB Stepper Controller | High Seas | General Electronics Discussion | 1 | 12-23-2003 11:25 AM |
| | |
stepper controller 
Linear Mode
