Need Help! Nema 23 270 oz/in. steppers is weak. Change the controller card? - CNCzone.com-The Largest Machinist Community on the net!

Vegabond · #1 10-07-2010, 01:51 PM

Hello, i have just changed my controller card to TB6560 4 axis card. The card burned up, so i haven`t tested it yet.

But my questinon is, how do i know how many oz/in the steppers run/use? has it somethings about the microsteps to do?

Hope someone can help me!

Greetings from Robert.

Dorsal · #2 10-07-2010, 04:11 PM

read this, it will answer a LOT of your questions: Geckodrive Technical Support Library

Vaffel · #3 10-08-2010, 05:41 AM

I don't believe the gecko drive support page answered his question(s).

To refine it a little: How is the microstepping affecting the performance of each step motor?

Will a 10 microstep driver make motors more powerful than a 5 microstep driver?

Or is the number of microsteps only affecting the degree of accuracy for each axis position?

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need Help!- New NEMA 42 steppers for BOSS mills	CNCISME	Bridgeport and Hardinge Mills	3	07-30-2010 12:56 AM
3 NEMA 34 Steppers on Ebay (No Reserve)	milhead	EBAY ADS	0	02-01-2010 12:04 PM
570 oz/in nema 23 steppers	cut more	Stepper Motors and Drives	2	10-01-2007 06:03 AM
Standard Nema 34's vs Nema 34's with encoder/controller.	SCCoupe	DIY-CNC Router Table Machines	2	03-16-2006 10:03 AM
3 (triple) stack, NEMA 23 steppers	Wm McNett	Stepper Motors and Drives	2	11-05-2005 08:52 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)