| |
|
#1
 
08-29-2010, 05:49 AM
| ||||
| ||||
Hi , what are Geko drives ?. Are they controller cards, or are they only motor drivers which are connected after the controller cards ?.   |
|
#2
08-29-2010, 06:37 AM
| ||||
| ||||
| Stepper and Servo drives. www.geckodrive.com
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
#3
08-29-2010, 06:43 AM
| ||||
| ||||
 So I can use any pci based controller cards with a geko drive, ryt ? |
|
#4
08-29-2010, 07:26 AM
| ||||
| ||||
| Anything that outputs step/direction signals
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
 |
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Newbie- Geko 540 | Bigguy63 | Servo Motors and Drives | 5 | 03-11-2010 01:26 PM |
| Simple, 3 Axes with Dual Drive/Motor (per axis), hardware splitter drive Interface. | kreutz | Stepper Motors and Drives | 3 | 07-03-2008 06:57 PM |
| motor geko fusing question | woffler | General Electronics Discussion | 0 | 02-03-2008 04:02 PM |
| geko 2002 project status ? | da21 | Gecko Drives | 3 | 12-14-2004 05:00 PM |
| geko 340 speeds | broncosis | Gecko Drives | 1 | 07-29-2004 06:08 PM |
| | |
Linear Mode
