Hi there everyone

I work in a computer repair shop
One of our customers came in with an Anilam 4200T system (just the silver control box with the boards and hard drive in it)
and showed us a picture of the issue
The system is getting stuck during post when switched on, it detects the hard drive shows the model and that SMART is detected but disabled and then just sits there doing nothing.
None of the buttons on the cnc respond.

All I can do is get in to the BIOS with the use of a keyboard, I have reset the BIOS to defaults with optimised setttings, even tried cloning the hard drive and trying another hard drive, but this has not worked.

I do not have direct access to the cnc machine so any help that I can tell the owner of the machine would be helpful.

Thanks in advance.
Mark

Similar Threads: