USB flash memory as bootdisk - CNCzone.com-The Largest Machinist Community on the net!

09-26-2004, 04:03 PM

slp_prlzys slp_prlzys is offline

Join Date: Mar 2004

Location: Canada

Posts: 210

USB flash memory as bootdisk

hello Group,

for those who wanted to use better bootdisk than slow floppy disk,
to run dos base controller.

If you have a newer motherboard that has the option of booting
from a USB device then you could check this,

I boot and learning turboCNC on a $5 Philips Keyring USB camera with 64MB ram.

__________________
Mhel
"me and my unselfish genes"

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Rediculous Fadal prices on memory	carbidecraters	Fadal	60	01-04-2011 02:03 PM
USB Breakout Board vs. Parallel	dwwright	Mach Software (ArtSoft software)	3	12-09-2005 02:30 PM
Awesome deal om usb memory	CNCadmin	CNCzone Club House	1	10-17-2004 09:41 PM
Memory issue	nervis1	Fadal	22	06-23-2004 06:47 PM
USB Stepper Controller	High Seas	General Electronics Discussion	1	12-23-2003 12:25 PM

All times are GMT -5. The time now is 04:01 AM.