Need industrial switch with good shielding - CNCzone.com-The Largest Machinist Community on the net!

mrnicks · #1 03-07-2007, 02:12 PM

I need a industrial switch or hub (unmanaged) with good shielding to be installed in a control panel. The environment is a typical clean panel. Does anyone have any recommendations with a price tag under $200. (at least 4 port)

bcromwell · #2 03-07-2007, 03:14 PM

If 10mbit will work I have an old IBM one with a solid alum. case. You pay shipping it's yours. 12 port I believe. Can send a picture and measure size if it might work for you.

cp8071 · #3 03-07-2007, 03:48 PM

Hirschmann Spider5TX
MOXA EDS-205
Weidmuller 8808230000

All are 5 port unmanaged switches. Not sure about the Hirschmann, but the others should be about $130. I think all are 24VDC with redundant power inputs.

CP

mrnicks · #4 03-07-2007, 04:54 PM

No thanks on the used one but thanks for the offer. We're a oem and can't sell machines with used parts if you get my drift. And, I'll check those others out.
Thanks.

mrnicks · #5 03-07-2007, 06:42 PM

No thanks on the used one but thanks for the offer. We're a oem and can't sell machines with used parts if you get my drift. And, I'll check those others out.
Thanks.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Use of shielding gas on wood....	sntlewis	Laser Engraving & Cutting Machines	5	03-13-2007 04:06 PM
Connection of shielding	cncuser1	General Electronics Discussion	2	06-17-2006 07:57 PM
Plasma noise (shielding)	AZCoyote	CNC Plasma and Waterjet Machines	7	01-15-2006 08:19 PM
RF shielding against plasma	HuFlungDung	Machine Problems, Solutions , Wireless DNC, serial port	6	11-18-2004 09:36 AM
Any Good Deals?(limit Switch)	FLUTE HEAD	General Electronics Discussion	17	08-13-2004 10:37 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)