| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Computers and Networking Discuss computer and Networking related questions here! |
| | |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
12-28-2011, 03:14 PM
| |||
| |||
CADCAM to 90's Trak cnc- Is it possible ? -------------------------------------------------------------------------------- Hi All, I have a 90's SouthWest Industries Trak cnc 3 axis Bridgeport in my home shop, that can no longer read the tape drive. Can I link it to a laptop and down load programs to it? I have experience with downloading dxf's and programming to controllers, but am not tuned in to the IT end of things. Any suggestions would be appreciated. Thanks, Eric  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| CADCAM to 90's Trak cnc- Is it possible ? | EricJ | General CNC (Mill and Lathe) Control Software (NC) | 0 | 12-27-2011 02:49 PM |
| Newbie- Fadal 4020/HT Early 90's | cam280 | Fadal | 5 | 11-22-2010 08:29 AM |
| 6-16bit processors vs not in early 90's CONTOURING | carbidecraters | Fadal | 0 | 02-24-2009 11:20 PM |
| Looking for uses of Dolphin CADCAM | CNCadmin | Dolphin CADCAM | 9 | 02-13-2007 10:48 AM |
| | |
Linear Mode
