LinkBack URL
About LinkBacks
Dear All,
We have got a machine with CNC and MMC. MMC has hard disk in it
As MMC screen was not coming, we have taken out MMC board, taken out Hard disk (IDE 40GB, Hitachi), cleaned a little fitted back
Now during booting, after memory check gets over
POST Startup error
Error 162 Configuration changes has occurred
Continue or Exit Setup
appears.
Tried with Load Default settings in BIOS still same problem
Sometimes error 8603 : Pointing device error appears although there is no keyboard/moubse conncected
In BIOS, found MOUSE installed, changed to "Not installed", saved this settings still we get error 8603 and find once again Mouse Installed under BIOS
Kindly advice
Best regards,
M. Rishikesh
