Cd-Rom Drive Trouble - Page 2 - CNCzone.com-The Largest Machinist Community on the net!

DieGuy · #13 05-14-2005, 04:40 PM

check in the autoexec.bat where the driver gets hooked, one of the options there is which drive letter.

CNCRob · #14 05-15-2005, 10:33 AM

Thanks again for the help. You all seem to know alot about DOS, I was wondering if there is anyway to automaticly start my controll software(which is CNCZEUS) when the computer boots. I have it stored on the hard drive and not the cdrom. Thanks again-Robbie

Al_The_Man · #15 05-15-2005, 10:52 AM

In your Autoexec.bat file, at the end, edit it to read:
CD C:\Cnczeus (the name of the directory where cnczeus is)
CNCZEUS ( or whatever the name of the program is)

CNCRob · #16 05-20-2005, 03:32 PM

I just wanted to thank everyone for your help. All of you helped me get the computer working just the way I wanted it to. Thanks- Robbie

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Driving a 4 pole ac servo with a 6 pole drive	TommyB	Servo Motors and Drives	4	04-28-2005 01:17 PM
Using a large drive on small motor?	murphy625	General Electronics Discussion	0	03-11-2005 04:23 PM
Help! ...no drive movement	CRFultz	General Electronics Discussion	4	01-21-2005 07:30 PM
Good DC motor and drive	JRoque	General Electronics Discussion	11	01-02-2005 09:38 PM
Belts versus Direct Drive	bsmith	DIY-CNC Router Table Machines	12	06-06-2004 10:09 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)