| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Commercial CNC Wood Routers Discussion Commercial CNC Wood Router Machines here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
09-09-2009, 01:37 PM
| |||
| |||
| MENUISER hell out thre guys, we need your help. could anyone tll us the best way to set up feed rate in busellato jet 3000 running genesis 2.0.3 . we mostly cut and profile 25mm Rusain birch with diamond tooling 20mm in diometre. thank you again .best regards menuiser.    |
|
#2
12-03-2010, 10:23 AM
| |||
| |||
| My Buselatto Jet 2000 router has quit picking up the collet from the tool carousel. It goes thru all the motions, but stops just short of descending & grabbing the bit. Just before this, I noticed case back grooves were not deep enough, so I reset bit from collet, reinstalled in carousel, began to get message: "Digital input MAIN GIO2JET Gio2. Ava waiting ON. Looked in Synoptic head, no green light in circle next to GIO2JET... |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| MENUISER | menuisier | Machine Problems, Solutions , Wireless DNC, serial port | 0 | 09-06-2009 03:15 PM |
| | |
Linear Mode
