Build Thread EZ-ROUTER - CNCzone.com-The Largest Machinist Community on the net!

CNCCajun · #1 06-21-2009, 04:58 PM

Would love to see an EZ-Router section . . . Can we hear from all the happy EZ-Router people . . . and the unhappy ones too, if any exist . . .

Steve

JD68 · #2 06-21-2009, 10:07 PM

Originally Posted by CNCCajun

Would love to see an EZ-Router section . . . Can we hear from all the happy EZ-Router people . . . and the unhappy ones too, if any exist . . .

Steve

I am interested in any info on the small ones. Good or bad.

TNX, JD

SASMachine · #3 07-07-2009, 09:49 AM

I am a very happy ez-router customer. i have two machines. This is my first day as a member of the zone. i have been following it for many months but decided today that i wanted to speak out.

I run my machines at least 4 days a week a piece and have had no problems other than user error. And even then the tech support was great and i was back up and running within minutes of calling.

I do not know much about the smaller ez-router machines but i would venture to say that if it is coming from ez-router it is a top notch machine.

Scott

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Build Thread- Building a CNC Router; by someone who can't build a CNC Router	Womble	DIY-CNC Router Table Machines	2	09-27-2008 07:51 AM
Newbie- Does anyone own a EZ Router Machine? Plasma or Router.	sngatlanta	Commercial CNC Wood Routers	30	04-11-2008 10:48 AM
Router Using 3/4" MDF (first router build)	eguy208	CNC Wood Router Project Log	33	04-11-2008 10:33 AM
Using a router for the 1st time. Need advice of cut speeds, router bits etc.	Apples	DIY-CNC Router Table Machines	19	09-23-2006 03:33 PM
Surfcam PP for Isel router / Precix router	IvanTochev	Post Processor Files	2	05-12-2004 12:27 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)