vytek rebel cnc router problems with NEE amc3 servo controller config!!!

[wjp9639]

Does anyone have the vytek rebel config for the amc setup program that came with the amc3 controller? I am trying to set this vytek rebel router up that I just purchased and cant seem to get the controller configured properly. Any help would be GREATLY appreciated from anyone who knows anything about the vytek rebel or the amc3 controller. Thanks Again!!!

[cabnet636]

are you in contact with the company, it is new right?

http://www.neecontrols.com/index.html

[wjp9639]

It's not new but I have the controller working with the vytek router now but I cant get the serial connection from the pc to the controller setup correctly now. I am trying to get the amc setup and winamc software to communicate with the amc3 controller. I was also wondering if there was a way to run mach3 on the pc and transfer the g codes and jobs to the amc3 if anyone knows. Any help would be greatly appreciated. Thanks Again.

[cabnet636]

i spent a few minutes reading thier page and it looks like a closed system to me, in other words you would have to disconnect the controller and take mach directly to the drives, there is a fellow named cnchelper here on the forum who may know more about this, other wise it liiks like a decent industrial controller, call the manufacturer and get the manual if you do not have one.

also you stated your machine is servo,

"vytek rebel cnc router problems with NEE amc3 servo controller config!!! "

the amc3 is a stepper controller

vytec is a listed advertiser on woodweb, i am sure they will answer the phone today

http://www.vy-tek.com/

jim

http://www.vy-tek.com/contact.html