general wood machining cnc questions

[matthewsutton]

hello all,
not sure if this is the correct area of the forum to post these questions but hoping im in the ballpark and someone can give me some guidance. i am looking to have a set of speaker faces cnc machined from solid stock walnut lumber. the original faces are made of plastic and i would like to these duplicated in the wood. i assume they can probe the originals and then cut from the solid stock. i am located in between charlotte and atlanta so i figure there must be some company in that range that would do a limited run of say 10 of these for me. the diminsions are roughly 10" by about 48". any input on how i should pursue this? any links to someone with a diy machine capable of doing this or a company that takes on smaller orders like this? any help greatly appreicated

[cabnet636]

there are a couple of ways

1 we are in columbia and would just need on for the template

2 try shopbots forum on finding a shopbotter in your area, theres a guy in fountain inn that does this

jim mcgrew
www.mcgrewwoodwork.com