| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Commercial CNC Wood Routers Discussion Commercial CNC Wood Router Machines here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
02-25-2008, 11:02 PM
| |||
| |||
Hi all. Just joined and submited a post in the Introduction thread at the club house. And yes I have a question. Since the ANDI 18 machine I am useing just came with limited G-Code package there are no drill cycles. I want to write MACRO to drill 7/16 holes in 3" Maple. Useing 4" drill bit. Any advice on tool path; feed rates; and spindel speeds? Right now useing... S4 F80. in steps Z-.625 Back up 100/1000's at 20 IPM and then 80 IPM to surface. Repeat another .625 in depth. This works fine. However sreaches some thing awfull. any sugestions?    |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Canned Cycle G73 Om Control Fanuc(drill) | marrieche | Fanuc | 1 | 03-05-2007 05:51 PM |
| canned drill cycle | nitrosnfr | General Metalwork Discussion | 2 | 05-24-2006 11:50 AM |
| error in drill cycle | TPPJR | OneCNC | 2 | 01-28-2006 01:21 PM |
| fanuc 15i problems with g81 canned drill cycle | KyDeano | Fanuc | 2 | 01-20-2006 02:39 PM |
| G83 peck Drill cycle | Vaughan | G-Code Programing | 24 | 03-19-2004 12:11 PM |
| | |
Linear Mode
