Does anyone own a EZ Router Machine? Plasma or Router.

[Todd W]

We have vcarve pro but dont know how to use it either.
Did cut a few little pieces on the plasma. We have one sheet of steel before changing over to the router.

[cabnet636]

check out vectric forum to see who uses it for torch work

http://vectric.com/forum/index.php?s...6646f59e6a51b1

i was looking at the videos of torch cutting on you tube


"http://www.youtube.com/watch?v=FHUs_u27IpE"]YouTube - Cutting a Sprocket with CNC plasma - PlasmaCAM

[cabnet636]

1" thinwall

what would you like to cut maybe i can show you in vcarve

"http://www.youtube.com/watch?v=LtE2J9MraXY&feature=related"]YouTube - VIBRA-FREE High Speed Aluminum Machining

[LBeagles]

I looked at EZ-Router shop twice last early year. I thought thier workmanship was average at best and ended up purchasing an LC4896 Techo-Isel that was delivered in July 07. After I compared item for item to have an EZ router built, the cost was not much different and would not compare to Techo machine. This is one of those companies that you get what you pay for (or a little less).

[cabnet636]

how you comming with your machine jim

[cabnet636]

was going to to see the ezrouter factory, wonder what he saw??

he started this thread!!

[BJamin]

Ok, so the more research I do the more confused I get. It would seem the arc voltage hieght control is a must, and servos aren't necessarily worth the extra expense for a small shop. (please don't start the debate again)

Did anyone else have input on an EZrouter table?
Anyone using a Precison Cutting System EasyLoader?

I'm new to CNC stuff and could use any and all input all of your expterise is very welcome!