Colombo burn out - CNCzone.com-The Largest Machinist Community on the net!

12-28-2007, 02:16 PM

Paul Petersen Paul Petersen is offline

Join Date: Aug 2007

Location: U.S.A.

Posts: 14

Paul Petersen is on a distinguished road

Colombo burn out

permalink

Anyone losing a lot of life from there 10hp Colombo spindles (draw bar type) due to them being in the same room with thermoforming equipment,or any other atmospheric conditions? The machines air supply is run through a dryer, and coalescent filter.
Tooling and programs are already tried and proven on identical spindle motors, that are in another building away from forming equipment. I do not have any problems with that machinery.

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Colombo Spindle wiring	powerfade	General Electronics Discussion	1	09-20-2007 03:13 PM
Few Questions on Colombo Spindles	thkoutsidthebox	CNC Tooling	8	09-16-2007 08:04 AM
Colombo / Komo RV90 spindle info help	tgrandahl	DIY-CNC Router Table Machines	1	03-28-2007 06:03 PM
R Shunt Burn	wanchai101	Servo Motors and Drives	0	03-26-2007 11:20 AM
burn	owhite	Laser Engraving & Cutting Machines	8	12-17-2005 03:17 AM

All times are GMT -5. The time now is 06:58 AM.