37 pin cable for controller - CNCzone.com-The Largest Machinist Community on the net!

dsgnkrft · #1 12-08-2007, 02:56 PM

Does anyone know the best place to get a new 37 pin male/female interface cable for my WinCNC controller system?

Thanks for your thoughts.

maxmachine · #2 12-08-2007, 05:43 PM

Originally Posted by dsgnkrft

Does anyone know the best place to get a new 37 pin male/female interface cable for my WinCNC controller system?

Thanks for your thoughts.

Hi... I use WinCNC also.... have you tried ordering from them? Their prices seem reasonable for spare parts.

Mark

dsgnkrft · #3 12-08-2007, 11:27 PM

I didn't see it available on their website, but thanks for the thought.

MarkWink · #4 12-09-2007, 12:41 PM

...try http://www.l-com.com - pricey but the quality is good

jdr · #5 07-16-2008, 09:33 PM

Try Bantam Electronics in Austin. www.bantamei.com

Part number is CAB-ST37FM-10-RH for $13.00

This one is 10 feet long. They also stock 6' and 3' lengths.

Late posting but this might help someone in the future.

Hardywood · #6 07-20-2008, 04:52 PM

http://www.l-com.com. If youre trying to run more than six feet you can chain them together.

jdr · #7 07-21-2008, 10:06 PM

$41.50 vs $13.00 for the same cable. HHHMMMM?

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
rs232 cable	Dar	Bridgeport and Hardinge Mills	7	12-13-2007 01:51 AM
DeskCNC 2nd. gen controller AND HobbyCNC Pro Controller	maycom	DeskCNC Controller Board	1	06-02-2007 02:33 PM
cable	lgalla	Stepper Motors and Drives	7	02-10-2007 10:55 AM
Heidenhain Cable	watzmann	CNCzone Club House	2	06-30-2006 08:02 AM
Shielded Cable	PEU	DIY-CNC Router Table Machines	5	06-13-2006 11:00 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)