| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Commercial CNC Wood Routers Discussion Commercial CNC Wood Router Machines here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
10-18-2007, 05:34 PM
| ||||
| ||||
I am seriously looking at a 24x36x4 cnc router fr5om motion tek wondering if anyone has delt with these people. 2hp spindle,cast aluminum,t-slot table, 220v volt power,ball screw xyz axix, res xyz .00038 repeatability .0008,micro step drive,usb interface any commnest would be appreciated stan    |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need help with CNC retrofit near Toronto | L98FIERO | Machines running Mach Software | 2 | 05-22-2007 01:06 PM |
| Circular motion with servo driven router | bunalmis | Servo Motors and Drives | 0 | 11-12-2006 06:30 AM |
| Toronto or GTA area | sfr | Mentors & Apprentice Locator | 0 | 10-17-2006 02:37 PM |
| Motion Master router | Jennifer | DIY-CNC Router Table Machines | 6 | 10-16-2004 12:26 PM |
| Can I use this motion controller to make cnc router? | Clasic31 | General Electronics Discussion | 7 | 12-11-2003 10:17 AM |
| | |
Linear Mode
