| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Commercial CNC Wood Routers Discussion Commercial CNC Wood Router Machines here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
09-09-2007, 01:17 PM
| |||
| |||
I have a northwood machine with a Fanuc 18m controller that lost the parameters. The machine was sitting for about 9 months and both batteries went dead. Memory and backup card. I have restored most parameters but the problem I am having is that I have to run machine real slow because arc's and corners over shoot. Never had this problem with this before parameters were lost.    |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| ABB S3 controller | memphiss | RC Robotics & Autonomous Robots | 1 | 06-10-2010 06:52 AM |
| DX-32 Controller | hilljk46052 | Bridgeport and Hardinge Mills | 5 | 08-09-2007 10:48 AM |
| DeskCNC 2nd. gen controller AND HobbyCNC Pro Controller | maycom | DeskCNC Controller Board | 1 | 06-02-2007 02:33 PM |
| CNC controller | justCNCit | General Electronics Discussion | 2 | 03-23-2004 02:32 PM |
| | |
Linear Mode
