| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Commercial CNC Wood Routers Discussion Commercial CNC Wood Router Machines here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
07-17-2007, 10:03 AM
| |||
| |||
Hi, I am new to this forum and I have a question for the expers. I have a MAXnc machine with a 4th axis. I just bought a techno-isel machine and I want to know if it is possible to use the 4th axis from one machine on the new techno. The machines have different posts, the techno has servo motors and the Maxnc has steppers. If it is possible how would you go about doing it. If anyone has any suggestions I would appreciate it. I really only want to use the 4th axis for indexing, but I want it written into the program so I can mill then index without having to index it manually. Tim  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| SOC-Machines 4-Axis Controller? | gt3073b | Stepper Motors and Drives | 8 | 04-22-2008 06:12 AM |
| installing compound angled holes on 3 axis machines | krustykrab | Hard and High Speed Machining | 8 | 10-13-2007 08:46 PM |
| new machines | daleman | Haas Mills | 4 | 02-24-2007 10:47 AM |
| Long Z axis machines | ynneb | DIY-CNC Router Table Machines | 2 | 02-01-2007 06:58 PM |
| 2 machines at once. | haas38 | General CNC (Mill and Lathe) Control Software (NC) | 4 | 06-26-2006 09:19 AM |
| | |
Linear Mode
