| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Commercial CNC Wood Routers Discussion Commercial CNC Wood Router Machines here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
06-05-2007, 11:23 AM
| |||
| |||
Hello, I'm new to this forum but was hoping someone may be able to help. I'm running a Techno 5996 gantry router and I'm trying to set up the 4th axis. I've programmed a simple path with Visual Mill to Horizontal rough the first face, rotate the 4th axis 90 degrees clockwise, then horizontal rough that side. As soon as the program gets to the rotation I get a "M4 position error (A axis); No Controller Power" error and the program stops. I can move the a axis through the interface without problems. If I post a table rotation only it does not run at all and the time estimate simply tracks the current time. When running a continuous 4th axis parallel finishing file I get the same position error. Has anyone faced this problem already? Thanks, Eric  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 5-axis tool setup | cdlenterprises | General Metalwork Discussion | 6 | 06-29-2009 12:48 AM |
| How do i setup my 4th axis on a maxnc? | artur83 | Safety Zone | 0 | 04-15-2006 02:45 PM |
| Axis setup problem | ckrantz | Xylotex | 2 | 12-31-2005 05:13 PM |
| Z axis setup | MrBean | DIY-CNC Router Table Machines | 4 | 09-26-2004 11:55 AM |
| Z Axis Setup | musicmkr | DIY-CNC Router Table Machines | 5 | 06-09-2004 11:33 PM |
| | |
Linear Mode
