DynaCNC 1000 Stepper w/ Gecko 201's

[gregrnel]

Does anyone who has this particular setup tell me what color the wires on the table I/O interface are. I'm trying to narrow down my problem. For the record I have, left to right

(X) dark blue, light blue, red
(Y) dark green, light green, black
(Z) orange, white,dark green (the other dark green, comes out of larger insulation with the black and red)

Every axis moves, so I'm assuming this is correct, although Y seems to have a slight delay when jogging at very low speeds (below 15%) with trimpot correctly adjusted.

Thanks!