Looking Andi Stratos table DWG - CNCzone.com-The Largest Machinist Community on the net!

G Daggett · #1 03-21-2007, 03:09 PM

We opperate a couple of anderson routers and i am trying to get my hands on a dwg or dxf file of the table top. It is a 1999 stratos WFD router with a boring block and 2 zone function. If anyone could help me out I would be gratful.

Thanks,

Gary

AlleyCat · #2 10-11-2008, 06:15 PM

I realize this is an old message, but I have table drawings if you still need them...I run a WFD as well. You wouldn't happen to have any information on macro programming for these things would you?

minty_jones · #3 05-02-2009, 10:48 AM

We just got a 2006 Stratos at our shop. Those drawings would be mighty handy if you're still around. Thx.

johnnyzero64 · #4 08-17-2010, 03:15 AM

Hi,
I would be greatful for any drawings of the above johnnyzero64@yahoo.com
I need to repair a gouged table, ahem.

maq_vega · #5 04-24-2011, 04:35 AM

Did you manage to figure out the Macros AlleyCat? also does anyone have the operation manuals (PDF/Scan) they could email to me? thanks

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
My DIY table	CNCadmin	DIY-CNC Router Table Machines	13	05-13-2008 08:28 AM
XY table design basics, linear ways to table size ratio?	Konstantin	Mechanical Calculations/Engineering Design	0	03-13-2007 12:21 PM
Anybody Seen Anything Like This X-Y Table?	silver	Stepper Motors and Drives	5	11-21-2006 10:50 AM
cnc table	mecano68	CNCzone Club House	0	11-18-2006 01:00 PM
Off goes the table!	zoeper	Bridgeport and Hardinge Mills	4	07-13-2006 07:35 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)