Please please help! Biesse rover a3.30

[XMARTYX]

Hi all,
I am a newbie to the forum, look like a good bunch of people. We have a biesse rover a3.30 cnc machine. We are starting to create kitchen carcasses in flat pack for fast production. We have always worked the old and slow way of drilling holes/ cams etc. i.e x= 100 y= 60 5mm drill bit. Additional page repeat steps of 32 repeat 20.

My question is, I would like to start using the formula way where we can type in x= lpx/3 (which we have the software, biesseworks) so it divides into 3 holes along the length, (side of wood, not top) I tried today, first hole appeared in a third of the board, but I can't repeat.

Sorry if it doesn't make much sense, but please any help would be truly grateful

[XMARTYX]

Figured it out now