| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Colchester Tornado lathes Discuss Colchester Tornado lathes here |
| | |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
11-09-2009, 06:55 AM
| |||
| |||
Hi, I had a small accident with tool change, and the Turret tried to change tool inside a workpiece. That didn't work of cource... My problem now is that the Tornado 300 shows alarm message AL1018, and will not reset the alarm. The turret is also not locked, i can turn it around. Anyone that have done the same fault i did and fixed it ? I have looked all over the manual, but can not find information to fix my problem. Controller is Fanuc OTC-F and the turret is Duplomatic Last edited by kama; 11-09-2009 at 07:38 AM.    |
|
#2
11-09-2009, 08:56 AM
| |||
| |||
| I have now fixed it. What I had to do was to open the Duplomatic logo cover and remove the Turretmotor cover. Then I pushed down the locking pin and turn the motor 3 revs to the right. The turret locking pin popped up again, but the position of the turret was correct. When I turned on the lathe again the error was gone.. Happy  Lets start production again |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Help!- Tornado 200 Fanuc ot not responding spindle and turret | tkea | Fanuc | 8 | 04-19-2011 05:44 PM |
| Colchester Tornado 200 Fanuc OT Control - Turret indexing problem | JohnWD | Fanuc | 10 | 12-29-2009 10:10 AM |
| Need Help!- Turret AMP Alarm and Lossing Position Signal | eva_1686 | Fanuc | 1 | 10-05-2009 11:32 AM |
| Need Help!- doosan 2020 turret alarm | sebturbo2000 | Daewoo/Doosan | 3 | 08-28-2009 04:03 AM |
| servo turret alarm | Hifeed | Fanuc | 2 | 08-15-2008 09:36 AM |
| | |
Linear Mode
