About 2 weeks ago i lost all the parameters for my colchester T110 lathe with 21i control,
After speaking to colchester i replaced the CNC battery behind the screen and re entered all of the parameters manually, encountering a few problems along the way!
When i switched the machine on this morning all of the parameters have gone again, i have checked the voltage across the battery and it is reading a steady 3v as it should,
What else will cause me to lose parameters? and what can i do about it?
Last edited by delta_david; 01-30-2009 at 09:51 AM.
Not sure about your model, I have a T8MS, and had to replace the Fanuc Servo batteries. Does it give you and codes etc... i.e. 300 or 306?