Need Help! Alarm Codes - CNCzone.com-The Largest Machinist Community on the net!

johngitts · #1 02-09-2011, 02:51 AM

Im currently running a Colchester Tornado 210 Cnc Lathe.

Ive powered up this morning and its thrown up an alarm :-

7112 SPN1: Overcurrent Pow Curcuit.

I dont have the correct for the machine and Ive looked at the curcuit breakers in the back but all looks fine.

Any ideas how I can repair said Alarm ?

Spindle doesnt run but Turret moves and fans etc all working fine

hmc710 · #2 02-11-2011, 05:03 PM

I think I had an over current alarm when I started up my 200 a while back. I cant remember if it was the crash switch or a phase issue. I'll check my notes and see but I think it was the crash switch.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need Help!- Need full list of G CODES AND M CODES FOR FANUC 21I	SonnyTees.com	G-Code Programing	3	02-23-2010 10:27 AM
Newbie- Citizen L20 Alarm codes	Q Special	CNC Swiss Screw Machines	3	11-20-2009 11:11 AM
fanuc om controller alarm codes?	Twin-10s	Fanuc	3	08-09-2009 11:47 PM
Mazak T2 alarm codes	pa2262	Mazak, Mitsubishi, Mazatrol	2	01-28-2009 07:53 AM
M-codes and G-codes 4 Matsuura ES-1000V	maximusek	G-Code Programing	2	11-27-2007 06:41 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)