Hello,
I have a cnc tour colchester (electronic triumph)
When I start the CN fanuc, I have this message (1008 AXIS OVERLOAD DETECTED).
and when I try to move on the X or Z axis, it moves a very small movement of 1 mm only and I receive a new message 414 X-axis detect error, after I check the diagnostic messages number 200 I found OVC = 1 (OVERCURENT) and when I set the reset the error is gone and it returns the same problem of displacement with 1 mm

I check the motor and the cables i found that they worked well.
I hope to find who to help me

Similar Threads: