backup


Results 1 to 2 of 2

Thread: backup

  1. #1
    Registered
    Join Date
    Dec 2011
    Location
    uk
    Posts
    4
    Downloads
    0
    Uploads
    0

    Default backup

    Hi how do back up your parameters on a 1997 Colchester Tornado 100.

    Similar Threads:


  2. #2
    Member
    Join Date
    May 2016
    Location
    United Kingdom
    Posts
    526
    Downloads
    0
    Uploads
    0

    Default Re: backup

    Step 1: Set up your Personal Computer (PC) or laptop to receive data. (click here for information on RS232 setup)
    Step 2: Punch out NC Parameters as follow
    Select EDIT mode.
    Select PARAMETER screen (by pressing PARAM/DGNOS key once).
    Press and hold EOB key while pressing OUTPUT START.
    * Note: OUTPUT will flash in the lower right-hand corner and NC parameters will be output.
    Step 3: Punch out PMC Parameters as follow
    Select EDIT mode.
    Select DIAGNOSTICS screen (by pressing PARAM/DGNOS key twice).
    Press OUTPUT START.
    Step 4: Punch out all NC Programs as follow
    Make sure parameter no. 10 bit#4 = 0 (unprotect programs 9000 ~ 9999)
    Select EDIT mode.
    Select PROGRAM Memory screen.
    Key in “O-9999”.
    Press OUTPUT START.
    Step 5: Punch out Offsets as follow
    Select EDIT mode.
    Select OFFSET screen.
    Press OUTPUT START.



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

backup

backup