- Colchester tornado 300 spindle problems
-
Registered
Colchester tornado 300 spindle problems
I just bought a call just to tornado 300 1998 lathe with the fanuc 0t controller
I've set the machine up and when I turn the spindle on, it runs for about six seconds then it turns off after about 6 seconds. 1001 spindle monitor comes up on screen but No alarm code comes up on the spindle servo unit. It does this on any RPM I set, however the spindle will run if I set the RPM 3 or less.
It has a barfeeder attached and I don't know if this has anything to do with the problem.
I'm very confused right now.
Not sure if this is a mechanical problem or a fanuc controller problem.
Has anyone come across this problem before?
Any help would be appreciated.
Cheers
Similar Threads:
-
-
Member
Re: Colchester tornado 300 spindle problems
Do you still have this problem?
- Colchester tornado 300 spindle problems
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules