Clive
You stipulate the angular rotation in the barfeed page accessed by pressing custom Graph
If you still cannot find it call me at the RK office and I'll talk you through
Darren
Tel 01322 447611
I am trying to feed hex bar on an A90 with MBF-1000 bar feed. Using M19 can I specify the rotation angle or is this fixed somewhere in parameters and if so where?
Any help would be very much appreciated...
Similar Threads:
- Tornado 200
- Tornado 200
- Need Help!- tornado 80
- Need Help!- Tornado T4 Lathe
- Need Help!- tornado 100
Clive
You stipulate the angular rotation in the barfeed page accessed by pressing custom Graph
If you still cannot find it call me at the RK office and I'll talk you through
Darren
Tel 01322 447611
It depends on how much the collet opens however to be safe i always pin the collet chuck clamp plate to stop movement
You can set it in the Bar feeder page after it has homed..............
Hello, can you send me a message and I will help you install parameters?
Hi Salih what is the serial number and the electrical diagram number
nsafos@canadianmachinetools.ca Phone number 1 647 308 3375
Nick Safos