Hi all,

I have made some progress with a Storm80 with Fanuc 21i controls that I bought, but it is still "stuck" in E-Stop mode for some reason. I was finally able to set the parameters to the correct 00110000 (a friend came by and eventually figured out that if you set everything to 00000000, and then set the parameter to 00110000 it will accept that). However, it did not change the behaviour. The machine is stuck in the E-Stop position and will not let me out yet. I checked the E-Stop switch for continuity, and the door switch also tested out good. One clue I have is it does not have the 24V at the E-Stop switch, but I can't find out why. I still have the following message: Alarm message 1001 spindle speed monitor - no response.

Does anybody have a Storm manual that has the troubleshooting portion? I have pdfs of manuals up through Section 7, but nothing on Sections 8-10.

The machine still has its parameters, but I don't have the original list. I am wondering now if I "boo-booed" one of them when trying to get this machine out of the 300 alarm.


Does anyone have the parameters for this particular model?
Model: Storm 80
Serial: T70129
600 Lathe No. T70129/126
Year of Build: 1998
Spindle RPM: 6000
Wiring Diagram: T80-055-0-031

Thank you again,
Bill Gillen
404 328 5826

Similar Threads: