Mirror macro

[goodfella]

I need to use G73 mirror macro on an Amada punch press. But I don't know how it's called. I thought it might go like this? "G73X..Y..W..C.." Is this correct? Any help will be deeply appreciated.
Goodfella

[Independent CNC]

If you are writing code by hand I understand why you would want to know this command. I have an Amada laser-programming manual that I think has that G73 cycle information that I can check your code if you like. Keep in mind that you will not have the optimal tool path when using canned cycles like this. You may want to invest in some CAM software to make programming easer and optimize your tool path.

Independent CNC Programmer
Home Page: http://www.ctcn.net/~3kings