![]() | |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| CNCzone Site News and Contests News pertaining to CNCzone as well as contests and give-a-ways. |
| This forum is sponsored by: |
![]() |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#13
| ||||
| ||||
| I'm pretty sure I checked "remember me" this morning, and 2 hours later I had to log in again. Maybe I forgot. It's odd that on three PC's I use I had to log-in on all of them, at basically the same time.
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
#14
| ||||
| ||||
| I had to log in the first time on different PCs also, but just the one time. After that, it remembers me. Scott
__________________ Consistency is a good thing....unless you're consistently an idiot. |
|
#16
| ||||
| ||||
| Ditto
__________________ www.integratedmechanical.ca |
|
#17
| ||||
| ||||
| At the risk of ? Me Too Haven't changed a thing and it will not remember me on THIS forum. All my others work as they are supposed to in the same browser.
__________________ Art AKA Country Bubba (Older Than Dirt) |
|
#18
| |||
| |||
I fixed the problem by deleting cookies for cnczone, logged out, logged back in(with remember me checked), logged out and then logged in again and it remembered me. Is it possible the format of the login data cookies changed with the new forum update? |
|
#20
| |||
| |||
| The site no longer accepts any UPPERCASE posting. THIS LINE WAS ALL UPPER CASE. The First Letter In Each Word Is Upper Case In This Line. Code: The site no longer accepts any UPPERCASE posting. THIS LINE WAS ALL UPPER CASE. The First Letter In Each Word Is Upper Case In This Line.
__________________ Ōz@®KÇÑÇ |
| Sponsored Links |
![]() |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Updated Website for Motion control | TRMInt | Product Announcements & Manufacturer News | 0 | 04-23-2007 04:57 AM |
| PICStep Firmware Updated | Garfield2 | PIC Programing / Design | 19 | 07-09-2005 10:30 PM |
| MiniDRIVEDC+ updated | Vider | Servo Motors and Drives | 0 | 06-15-2005 03:58 AM |
| updated OneCnc website | steveag | OneCNC | 1 | 07-18-2003 05:37 AM |
| CNCzone.com Forum Rules & Privacy Policy (updated 2-14-08) | CNCadmin | CNCzone's Community Policies | 0 | 03-01-2003 07:41 AM |