![]() | |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| CNCzone Club House Discuss everything in between CNC. THIS IS NOT A TRASH BIN. |
| This forum is sponsored by: |
![]() |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
| ||||
| ||||
I don't know if anyone else noticed but it seams the site is blazing fast, I made some changes last night and it seams to have sped up the site.
__________________ Thank You, Paul G Site Owner-Webmaster- Administrator www.rfqwork.com www.cnczone.com www.welderzone.com |
|
#5
| |||
| |||
| Oh dear! that's bad news for me then. Here I was thinking the site getting slower every time but from reading the above it's obvious that problem is with my computer not this site. If, with one page open at "Daily Posts", I then right click four new posts each in a new window it takes just over 3 minutes (tested right this minute) and that's with 512ADSL broadband. Hmmm... it's technician time! Skippy |
| Sponsored Links |
|
#8
| ||||
| ||||
| I do see it is faster good job Paul. What you do give them more money for more speed. J/K
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) Cadcam Mastercam Instructor , Programming Consultant and ME (Manufacturing Eng) |
|
#9
| ||||
| ||||
| Seems a bit faster than before, about 2 seconds to open a forum message in a new window, about the same to open this reply page...was definitely acceptable before..shows about 350 users on now with no noticable speed slowdown.. was a bit erratic last night, threw quite a few database errors, probably about the same time as you were doing the changes... |
![]() |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| CNC Controlled Spindle motor speed control | gregmary | General Electronics Discussion | 13 | 02-27-2009 08:01 PM |
| Spindle Speed & Feed Rates - Question | Moondog | DIY-CNC Router Table Machines | 1 | 07-23-2004 07:24 PM |
| site stats world wide! | lsfoils | CNCzone Club House | 2 | 04-10-2004 12:33 AM |
| min speed exceeds max speed for axis "x"? | ljoe1969 | TurboCNC | 4 | 01-19-2004 08:49 AM |
| AC Speed Control | georgebarr | General Electronics Discussion | 7 | 01-06-2004 08:33 PM |