Got to love it "Made in China"

[Hennessy]

So the guy that owns the shop i work in loves to buy stuff at auctions .... most of the time he does really well picking up good stuff cheep.... for the most part any way .... so long story short i start digging threw the new batch of stuff to see what we can use and i find this on a box of pins ... i don't think a reference only sticker quite covers it the pins are as accurate as the chart by the way some of them are -.0007 off the marked size.

If u cant read all of it i will post a better photo tomorrow.

Note: I stopped looking at the chart after i found 4 wrong. The set is complete and unused, and i know why

Hennessy

[heilcnc]

i would have got rid of them to hope he paid $2.00 for them they would be good to hammer
out stuff with!!!! that all

[Hennessy]

they would be good to hammer out stuff with!!!! that all

lol i don't think they are even good for that... they would probably explode and go right in to my finger ...i am not allowed to throw them away but i can't be forced to use them

Hennessy

[heilcnc]

you can do what i did when i got a chinese drill set to get the case and thru time replaced all the drills with all quility made in the usa drills and junked the others!!!!(they are worth
more in scrap)

[youngjim]

I've been looking everywhere for a 1/46" pin!

Jim